Trailer Hub and Taper Bearings

Hi Nigel, the bearing shells are fitted in the hub but the bearings themselves are held in place by the stub axle and securing bolt/washer when the hub is fitted. David

Hi ChrisWe don't stock a bearing buddy sorry. They do have a grease nipple thoughRegardsDavid

Hi Richard We can organise international shipping and the best way to find carriage costs is add items to your cart, then view cart and you should see a shipping calculator (may need to click the down arrow next to Estimate Shipping) which requires basic info and will give you the available options. If there are no options for what you have selected then email us what you want together with a full delivery address and we will ask our couriers for quotes Regards David

Hi Malcolm You will need a 25mm bearing set, our 1 inch bearing won't be right on a 25mm Regards David

Hi Michael Yes these hubs have a grease nipple Regards David

Hi Perry Our phone number is on the contact us page and at the bottom of every page 01914901736 Regards David

Hi Edward The hubs and bearings are supplied dry so you can add the grease of choice, not all greases are the same of compatible. If you are putting the bearings in water then a waterproof grease like K99 or Ramonol will help and remember to avoid putting the bearings in the water when warm Regards David

Hi Peter I'm guessing you are referring to launching trolleys and it is not possible to convert them for road use. It is however possible to connect the trolley to a vehicle for short off road use (pulling up a beach or ramp) using our Tow Ball coupling https://www.tridentuk.com/gb/product-tow-ball-coupling-for-launching-trolley-trtrabc-trol.html Regards David

Hi, the PCD of the hub needs to match that of the wheel for the hub to fit. To check this measure from the centre of one stud hole to the centre of the stud hole diagonally opposite, this should be 4" to match. FYI an 8" wheel has an overall diameter of just under 9", the bit that the tyre attachs to is 8" diameter.

Hi Niazi, The hub we supply doesn't need a spacer between the bearings as they will sit in the tapered shells Regards David